拉伸强力提升剂
TexTrit® Strength Boost
拉伸强力提升剂TexTrit®Strength Boost 适用于棉、粘胶、涤纶、化纤及其混纺织物，可以有效减少织物之间的摩擦，提高织物断裂强力及化纤织物断裂强力，根据面料及用量的不同，可以适当提升30%-100%左右的拉伸断裂强力，同时兼具良好的顺滑手感。
一、物化性能
外观 乳白色液体
离子型 弱阳离子型
pH 近中性
溶解性 易溶于水
二、使用方法
本产品适用于各种印染加工设备
.浸轧法
TexTrit®Strength Boost 30-40g/l，100-130℃定型
.浸渍法
TexTrit®Strength Boost 2-4%，浴比1:10，30分钟脱水烘干（100-130℃）
贮 存
1.避免阳光直射，密闭保存在室内通风处（0-35℃下保存），使用后记得及时封口
避免出现结块现象。
2.产品为弱阳离子型，与其他离子型合用前，请预先做相容性实验确认。
3.不可将其置于阳光暴晒处或其他高湿高热处。
重 要 声 明：以上数据和结果基于公司目前拥有的认识和经验,以及受限的实验室条件,仅供 参考，敬请客户根据自身条件通过试验加以确认。本公司不承担未经小样确认而投入生产所造成的损失！
Tensile Stength Improver
TexTrit® Strength Boost
It is suitable for cotton, viscose, polyester, chemical fiber and their blends. It can effectively reduce the friction between fabrics, improve the breaking strength of fabrics and chemical fiber fabrics. According to the different fabrics and dosage, most of them can increase the tensile breaking strength by about 30% - 100%, and have a good smooth hand feel.
Physical & chemical properties:
Appearance: Milky white liquid
Ionicity: Weak cationic
pH: Near neutral
Solubility: Soluble in water
Usage:
This product is suitable for all kinds of dyeing equipment.
Padding method
TexTrit®Strength Boost: 30-40g/L, heat setting at 100-130 ℃
Impregnation method
TexTrit®Strength Boost: 2-4%, bath ratio 1:10, 30 minutes of dehydration and drying (100-130℃)
Storage:
1. Avoid direct sunlight, store in a indoor ventilated place (0-35 ℃), and remember to seal in time after use to avoid caking.
2. The product is of weak cationic type. Please confirm the compatibility through test in advance before mix-using it with agent of other ionicity.
3. Do not place it in the blazing sun or other places with high humidity and heat.